Digitrax Zephyr DCC Starter Set

Zephyr Offers:

• Simple to use controls for running trains.
• Large speed control knob and direction switch with brake.
• Full numeric key pad.
• Easy 2 and 4 digit addressing.
• Smooth speed control.

Run multiple trains at once without blocking!

• Run up to 10 addresses at the same time on your system.
• Run up to 10 throttles at the same time on your system.

Jump Ports for using DC power packs as additional throttles

• Use one or two smooth DC power packs as throttles to control DCC equipped locomotives.
• Simple, cost effective way to add more throttles to your Zephyr set.
• Makes it easy to share the fun of DCC with layout visitors and young operators.
• Functions on locos controlled by Jump throttles remain active.

Over 9000 Locomotive Addresses

• Use Address 00 to run one or more locos without DCC decoders
• Two Digit Addressing is easy to use. (Address 01-127)
• Four Digit Addressing-use the number painted on your engines as its address.

2.5 Amps of Power to run multiple trains.

• Booster outputs 12V for safe operation in N and HO scales.

Function Control

• Control 10 functions-F0 through F8.
• Function 2 is a special non-latching key that can be used to sound the horn for as long as the key is held down.
• Constant brightness lighting. Headlights can be directional or independently controlled (depending on decoder).

Stationary Decoders, Turnout Control & Turnout Position Reporting

• Access to stationary decoder control for turnouts and other devices.
• Control 999 stationary decoder addresses.

Consisting

• Universal consisting, Digitrax preferred method. ALL locos can be consisted, even analog locos.
• Advanced consisting, allows only advanced consist capable mobile decoders.
• Basic consisting, program decoders to run on same address.

Decoder Programming

• Built in read/write programmer that can read and write all CVs.
• Supports Paged programming (Digitrax preferred method). Also supports direct & register mode programming.
• Operations mode programming can be used to program decoders on the layout.

Expandability with Digitrax LocoNet

• Use Zephyr as a starting point for your Digitrax LocoNet System, then add components.
• Use Zephyr as an expansion set with Digitrax equipment you already have installed.
• Add Radio or IR via LocoNet. Just plug in a UR90 or UR91 receiver and add IR and/or Radio throttles.